Panasonic kx-fmc230 - Manual (Page 96)

Error Messages
Error messages on the LCD display
If the unit detects a problem, one or more of the following messages will appear on the display.
DISPLAY MESSAGE CAUSE & REMEDY
[
CALL SERVICE
»There is something wrong with the unit. Contact our service personnel (p. 122).
CHECK COVER
•The front cover is open. Close it.
CHECK DOCUMENT
►The document is not fed into the unit properly. Reinsert the document. If
misfeeding occurs frequently, clean the document feeder rollers inside the unit
(p. 114). If the problem remains, adjust the feeder pressure (p. 109).
CHECK FILM
►The film cartridge is not inserted properly. Reinsert it correctly (p. 110, 111).
CHECK LEVER
•The recording paper set lever is released. Push the lever back to reset (p. 20).
CHECK MEMORY
• Memory (phone numbers, parameters, etc.) has been erased. Re-program,
CHECK PAPER
•The recording paper is not installed or the unit ran out of paper. Install paper
(p. 20).
•The recording paper is not fed into the unit properly or has jammed near the
recording paper entrance. Clear the jammed paper (see “When paper has
jammed near the recording paper entrance” on page 108).
Do not install folded or heavily curled paper in the paper tray.
FAX IN MEMORY
•The unit has (a) document(s) in memory. See the other message’s instructions to
print out the document(s).
FILM EMPTY
•The film is empty. Replace the film or film cartridge with a new one (p. 110, 111).
•The film is slack. Tighten it (see step 8 on page 111) and install again.
FILM NEAR EMPTY
»The remaining film can print approx. 15 pages of letter size documents. Prepare a
new film or film cartridge (p. 7).
MEMORY FULL
►The memory is full of received documents due to a lack of recording paper or a
recording paper jam, etc. Install paper or clear the jammed paper.
►When performing memory or multistation transmission, the document being stored
exceeds the memory capacity of the unit. Transmit the entire document by using
manual or automatic transmission.
NO RESPONSE
»The receiving unit is busy or ran out of recording paper. Try again.
PAPER JAMMED
»A recording paper is jammed under the film cartridge. Clear the jammed paper
(p. 107).
PC FAIL OR BUSY
»The fax function cannot be operated by the PC. The RS232C cable is not
connected correctly, or the software is not running on the PC.
96
For Assistance, Call 1 -800-435-7329