Panasonic NV-H65 Series - Manual (Page 21)

D a D
o o o Q § S B □ 1 1
The Timer Recording Buttons {Check/Programme, Next,
Timer Record) of the Remote Controller have the same
functions as the Check/Programme, Next, Timer Record
Buttons on the VTR. Therefore, instead of using the (+)and
(-) Buttons on the VTR, the Timer Recording & Pro­
gramme Position Selector Buttons of the Remote Controller
can be used to programme timer recordings.
How to Select the Programme Position (Channel)
select channel press button
1-9
10
11-16
for example 12
CD
respective channel
1 su 2MC
CD CD (-------1
If more than 5 seconds pass between the first, second and
third push, the channel will not be changed normally.
How to Set the Date and the Starting & Ending Times
for Timer Recordings
The date and time can be set. by directly pressing the
number buttons ffT~sul~|id/oiT When two buttons have to be
pressed (for example, when setting the date to a day of the
month between 11 and 31, the hour between 11 and 23, the
minute between 11 and 59), the second button must be
pressed within 2 seconds after pressing the first button.
Preparation
•Make sure that the clock shows the present time correctly,
•Insert a video cassette with the erasure prevention tab
intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Make sure that the “Timer Record” is not switched On.
•Set the Input Signal Selector to “Tuner”.
For Example:
Programming a timer recording for a TV programme that
will be broadcast on Wednesday, October 28, from 20:00 to
22:45, on programme position (channel) 12, on timer
programme number 2. (Present date=October 10, 1987)
Press the Check/Programme Button to select the next
unoccupied timer programme number.
I 9
PROG
/ E \
Press the (+) or (-) Button to select the programme
position (channel) on which the TV programme will be
broadcast.
^ Press the Next Button.
21