Panasonic NV-H65 Series User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SYMPTOM
CAUSE
REMEDY
Power doesn’t turn on.
Mains lead is not connected.
Connect mains lead to mains outlet.
The Timer Record Button is set to “On”.
Set the Timer Record Button to “Off".
Power is on but unit doesn’t
operate.
Dew condensation inside the VTR.
Wait until the Dew Indicator “ d ” goes off,
Safety devices are operating.
Turn off the VTR On/Off Switch, disconnect
mains cord from outlet, then reconnect mains
cord to mains outlet and turn on the VTR
On/Off Switch again.
TV programmes cannot be
recorded.
Connection of aerial lead is not correct.
Connect aerial lead correctly.
Reception channel is not properly tuned.
Tune reception channel.
The input Signal Selector is not set correctly.
Set the Input Signal Selector to “Tuner”.
OTR Function (One-Touch Timer
Recording) cannot be performed.
Clock is flashing “0:00’’.
Set clock to present time.
Unattended timer recording
cannot be performed.
Recording start or recording stop time setting
is incorrect.
Set recording start and recording stop time
correctly.
The Timer Record Button is set to “Off”.
Set the Timer Record Button to “On”.
Clock shows incorrect time.
Adjust clock to present time.
Clock is flashing at “0:00”.
Set clock time and perform timer setting.
The Input Signal Selector is not set to
"Tuner”.
Set the Input Signal Selector to “Tuner".
Unattended timer recording
cannot be programmed.
The OTR is now being performed.
Programme the timer recording after the
OTR has finished.
If you attempt to carry out
Recording, Timer Recording, or
OTR, the cassette will be
automatically ejected.
Accidental erasure prevention tab on the
cassette is broken out.
Cover tab hole with adhesive tape.
Recording via external input
terminals cannot be performed.
The Input Signal Selector is not set correctly.
Set the Input Signal Selector to “Line/Audio”.
28