360 Systems DigiCart/II Plus - Manual (Page 53)

DigiCart/II Plus Owner's Manual Operating Instructions • 41
Erase
ERASE permanently deletes the currently selected cut, stack, directory or disk. Once something
has been erased, you will not be able to "recover" it. You can cancel an erase procedure in progress
by pressing the CANCEL button. A copied cut with the same name, located in other drives,
directories or stacks will not be affected. A copied directory or stack will have a different ID and
will not be erased.
1. Navigate to the cut, directory or drive you want to erase.
2. Press the UTILITY MENU button and rotate the SELECT control until the display
shows:
ERASE
PRESS ENTER/CANCEL
3. Press the ENTER button. The display will show either:
X.XXXX CUT NAME
PRESS YES TO ERASE
OR
X.XXXX DIRECTORY NAME
ERASE DIRECTORY?
OR
X.XXXX CUT NAME
ERASE ENTIRE DISK?
Make sure that the ID and name appearing in the top line of the display is what you intend to erase.
4. Press the ENTER button to erase the selected item. Press the CANCEL button to
exit this function without erasing the selected item.
For each cut that is erased, the display will briefly show:
ERASING
ID NAME
Copy Original
DigiCart/II Plus provides the flexible ability to copy the contents of drives, directories, cuts and
stacks to any location of the same type. This feature can be an important time-saver because
grouped materials can be mass-copied. Often you will need two or more almost identical stacks
with only one or two items that are different. A stack can be copied and then quickly edited to
change those cuts. The copies are easily renamed to avoid confusion.