360 Systems DigiCart/II Plus - Manual (Page 90)

78 • File Transfer Network DigiCart/II Plus Owner's Manual
IN OUT
DigiCart/II Plus DigiCart/II Plus
IN OUT IN OUT
DigiCart/II Plus
OR
RECEIVER INPUT
OFF
2. If desired, use the Left and Right POSITION buttons to select the
alternate menu item. Confirm your choice by pressing the ENTER
button.
Echo Function
If your D-NET network is configured in a “Daisy Chain” and the Echo Function is ON,
you will be able to relay the incoming transfer to the digital input of a DigiCart/II Plus to
the digital output on that machine and on to the next DigiCart/II Plus in the network.
A DigiCart/II Plus “Daisy Chain” Network
To set the Echo Function on your DigiCart/II Plus Receiver:
1. Press the D-NET XFER button. Rotate the SELECT control until the
display shows either:
ECHO DURING RECEIVE
OFF
OR
ECHO DURING RECEIVE
ON
2. If desired, use the Left and Right POSITION buttons select the alternate
menu item. Confirm your choice by pressing the ENTER button.
NOTE: If a DigiCart/II Plus in the network is powered OFF, is in a Play or Record mode,
or has its D-NET Receive off it will NOT “Echo” or relay the transfer to the next
machine in the network. This is true regardless of the configuration determined during
Setup.
Echo should be turned off whenever the digital outputs are used for audio transmission.
Using the digital outputs for digital audio with Echo on can cause clicks and pops in the
unit receiving digital audio from the DigiCart II/Plus. Facilities that make extensive use
of digital audio should consider the use of a distribution amplifier or router and