360 Systems DigiCart/II Plus - Manual (Page 79)

DigiCart/II Plus Owner's Manual Stack Mode • 67
Playing A Stack
Playing A Linear Stack
Linear Stack IDs are followed by an " L ". All items in a Linear Stack will play in sequence
without interruption.
1. Rotate the SELECT control until the name of the Linear Stack you want appears in
the display.
1.SXXXL NEWSTK_XXX
ITEM NAME HH:MM:SS
The bottom line shows total stack items and total stack time.
2. Press PLAY.
Once you begin playback of a Linear Stack, the current selection and its playing time will be shown
on the bottom line of the display.
Using The Stop Button In A Linear Stack
When in a Linear Stack, pressing STOP button once will discontinue playback at the end of the
current cut. The PLAY button will illuminate continuously, indicating there are no longer any
follow-on events to be played. Pressing STOP twice will immediately discontinue playback of the
stack. Once the PLAY light has gone solid, indicating the last cut, Pressing STOP will
immediately end playback.
Playing A Rotating Stack
An “R” follows Rotating Stack IDs. Only the currently selected event in a Rotating Stack will play.
1. Use the SELECT control until the name of the Rotating Stack you want appears in
the display.
1.SXXXR (STACK NAME)
X HH:MM:SS
2. Press the PLAY button. The event at the bottom of the stack will play. Each
subsequent press of the PLAY button will cause the next event to play.
NOTE: Each time a Rotating Stack is accessed, it will play the next event. To reset the stack to any
other selection, edit the stack and use SCAN. Upon power up, all Rotating Stacks are reset to play
the first event in the stack.
Viewing A Stack
To check the contents of a stack:
1. Press the VIEW LIST button.
2. Use the SELECT control to scan the contents of the stack. The display will show: