Adaptive Technologies 2X4-UE46A-VWD - Manual (Page 2)

© 2013 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-02/18/13
Figure 3
Figure 4
Step 3: Install Locking Arm brackets
Assemble the 9-0696 locking arm bracket on
TWO of the Upper framed 9-0676 H-slat and two
on the Lower frame’s 9-0676 H-slat near the
rectangular slot using the provided M4 screws,
nylon washer and nylock nut (Figure 3). The
locking arm brackets must be installed on the
first and third horizontal H-slats of the upper and
lower frame starting from the top. Make sure the
hook of the locking arm bracket faces up (Figure
3). Tighten screw to increase locking arm
friction.
Step 4: Assemble the Upper Frame
Assemble the top upper frame by attaching the
horizontal H-slats, (9-0676 to the 2X V-channels
(9-0678) using the provided M6x20mm long flat
head screws. Screw-in all screws half way first,
do not tighten screws until all screws are
installed. Check for squareness by measuring
corners to corners then tighten screws starting
with the screws on the holes then the screws on
the slots of the H-slats (Figure 5).
Step 5: Assemble the Lower Frame
Assemble the top lower frame by attaching the horizontal H-slats, (9-0676 to the 2X lower V-channels (9-0640) using the provided
M6x20mm long flat head screws. Screw-in all screws half way first, do not tighten screws until all screws are installed. Check for
squareness by measuring corners to corners then tighten screws starting with the screws on the holes then the screws on the slots of
the H-slats (Figure 6).
Step 6:
Join the upper frame and the lower frame together using the 9-0644 vertical joiner plate (Figure 7 and main illustration). Tighten
screws permanently.
Step 7:
For wall installation, refer to product installation guide.
Figure 4
Lower Frame (Figure 2)