Adaptive Technologies 2X4-UE46A-VWD - Manual (Page 8)

© 2013 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-02/18/13
Figure 9
Step 7: Install Monitors to the right Column
Starting with the top monitor, connect the power and signal wires to
each monitor then align its four M8 adjustable VESA buttons with
the four large slots in the H-slats. Slide the monitor from right to left
until it is snug against the left column monitor (Figure 8). Repeat
step 7 for the lower monitor. Check for front and side alignments-
refer to Step 6.
Servicing Tips
Left Column Monitor Removal
Reach fingers between the left side wall and the monitor and lift the
locking arm to unlock. Slide monitor to the LEFT about 1.00”
(25.4mm) until its VESA buttons disengage from the frame, lift a
little to support the weight of the monitor then slowly pull to remove
(Figure 9).
Right Column Monitor Removal
Reach fingers between the wall and the monitor and lift the locking
arm to unlock. Slide the monitor to the RIGHT until its VESA
buttons disengage from the frame, lift a little to support the weight
of the monitor then slowly pull to remove (Figure 9).
Figure 7
Figure 8