Adaptive Technologies 2X4-UE46A-VWD - Manual (Page 7)

© 2013 Adaptive Technologies Group, Signal Hill, CA 90755 USA (562) 424-1100 Rev.00-02/18/13
Figure 6
frame back towards the wall (Figure 4). Use a long level, a straight edge or a piece of string secured on each side of the frame to make
the horizontal H-slats straight by adjusting the adjustable lag bolts closest to the H-slat. Once the frame is plumbed and leveled, tighten
all hex nuts permanently.
Step 4: Install Adjustable VESA buttons to monitors
Thread the M8 adjustable VESA buttons to the VESA mounting holes in
the back of each monitor using a Phillips head screw driver (Figure 5).
Step 5: Install Monitors to the Left Column
Lift up the locking arms on the left side of the frame. Starting
with the upper left monitor, connect power and signal wires to
each monitor then align its four M8 Adjustable VESA buttons
with the four large slots in the H-slats then slide the monitor
from left to right until it stops. Pull down the locking arm to lock
monitor into place (Figure 6). Repeat step 5 for the lower
monitors.
Step 6: Note on alignment:
While installing monitors, check for front and side alignment of the
monitors. The surfaces of all monitors must be aligned and flush to each
other. If one or more screens are tilted more than others use the
adjustment wrench to reach the hex portion of the M8 adjustable VESA
buttons at the rear of the monitor then rotate counter clockwise to pull the
front of the monitor forward or clockwise to push it back towards the wall. If access to the rear is not accessible remove the screen(s)
and depending whether the monitor needs to be tilted forward or backward rotate the buttons using the adjustment wrench, a phillips
head screw driver or fingers (Figure 7). Reinstall and recheck surface alignments. Repeat where necessary.
Figure 5
Figure 3
Figure 4