ALFA NETWORK AIP-W505 - Manual (Page 72)

C HAPTER 7 | Wireless Configuration
Advanced Settings
– 72 –
◆ ACM — The admission control mode for the access category. When
enabled, clients are blocked from using the access category.
(Default: Disabled)
◆ AckPolicy — By default, all wireless data transmissions require the
sender to wait for an acknowledgement from the receiver. WMM allows
the acknowledgement wait time to be turned off for each Access
Category (AC) 0-3. Although this increases data throughput, it can also
result in a high number of errors when traffic levels are heavy.
(Default: Acknowledge)
M ULTICAST - TO -
U NICAST C ONVERTER
The Multicast-to-Unicast Converter section on the Wireless Settings
Advanced page allows you to enable multicast traffic conversion.
Converting multicast traffic to unicast before sending to wireless clients
allows a longer DTIM (Data Beacon Rate) interval to be set. A longer DTIM
interval prevents clients in power-save mode having to activate their radios
to receive the multicast data, which saves battery life.
Figure 38: Multicast-to-Unicast Converter
The following items are displayed in this section on this page:
◆ Multicast-to-Unicast — Enables multicast traffic streams to be
converted to unicast traffic before delivery to wireless clients.
(Default: Disabled)