Alyseum MS-MATRIX - Manual (Page 7)

MS-MATRIX – User’s manual © - Revision 1.5
Page 7
5 Software
5.1 Initialization Sequence
1. Turn the Eurorack case power on
2. The brand name Alyseum is displayed on the LED array for less than a second
3. The three mode LEDs flash for half a second each
4. The matrix stored in the last used Preset is loaded and displayed
on the LED array.
5. A MIDI signal is sent via IR, informing slave modules that the
particular Preset has been loaded.
5.2 Mode Selection
Push the Mode button to select the desired mode
● No Mode (All LED Mode Off)
● IN / OUT
● PRESET
● MIDI / CV
5.3 IN / OUT Mode
To select a connection between an input and an output on the matrix:
1. Select IN/OUT Mode (see paragraph 5.2)
2. The line and column guides appear on the LED array.
3. Turn the INPUT/SAVE encoder to select a row.
The selected row number corresponds to the input jack of the same number
4. Turn the OUTPUT/LOAD encoder to select a column.
5. The selected column number corresponds to the output jack of the same number
To activate the selected connection push either the INPUT/SAVE or the OUTPUT/LOAD
encoder until the corresponding LED is turned ON. The line and column guides disappear.
To deactivate the selected connection push either the INPUT/SAVE or OUTPUT/LOAD
encoder until the corresponding LED is turned OFF. The line and column guides disappear
To move on to another connection, turn the INPUT/SAVE or the OUTPUT/LOAD encoder
and then go to step 4 .
The MS-MATRIX does NOT function as a mixer. Please refer to the expander for mixer
function.
While it is possible to map one input location to several output locations (and thus have the
MS-MATRIX act as a multiplier), it is impossible to map several inputs to the same output.
IN / OUT
PRESET
MIDI / CV
No Mode