Alyseum MS-MATRIX - Manual (Page 9)

MS-MATRIX – User’s manual © - Revision 1.5
Page 9
5.4.3 Saving a Preset Automatically
When Auto Save is activated (see paragraph 5.6.2) there is no need for any action in order
to save a Preset as any change made is automatically saved.
This means that by activating or deactivating a connection while in IN/OUT Mode you also
alter the matrix saved on the specific Preset location.
5.5 MIDI / CV Mode
To select the method of loading a Preset:
1. Select MIDI/CV mode (see paragraph 5.2)
2. Turn the INPUT/SAVE encoder to select one of the five settings:
(see Operation Snapshot below).
A. PGM XX: Selects Preset by MIDI Program Change
messages (PGM CH) coming from the front panel MIDI port
(XX = MIDI channel 1 to16)
B. NOTE XX: Selects Preset by MIDI Note On messages
incoming from the front panel MIDI port (XX = MIDI channel 1
to 16)
C. CV FR: Selects Preset by CV coming from the front panel
input labeled CV (0 to +5 Volts)
D. CV MN: Selects Preset by the Make Noise CTRLSEL line of
modules
(0 to +5 Volts)
E. — — : Selects Preset only manually (see paragraph 5.4.1.)
3. Push the INPUT / SAVE encoder to confirm your selection
4. Your selection has been saved as soon as the MIDI/CV Mode LED is turned Off.
When one of the five MIDI/CV Mode settings has been selected any incoming activity,
either from the MIDI IN input or the CV input, will be indicated by the flashing MIDI/CV
Mode LED.
All Preset changes due to midi or analog signals are ignored while IN/OUT Mode,
PRESET Mode or MIDI/CV Mode is active.
5.6 Settings
5.6.1 Assigning a MIDI Note to Preset 01
By default Preset 01 corresponds to key C3 (MIDI Note 48). Consecutive chromatic notes
correspond to the rest of the Preset locations as shown below.
PGM 01
PGM 16
NOTE 01
NOTE 16
CV FRONT
CV MN
__ __