Cannon Instrument CT-600 (Contant Temperature Bath) - Manual (Page 9)

7
CANNON CANNON CANNON CANNON CANNON ® CT-500/600 Series II CONSTANT TEMPERATURE BATH
Version 3..2—March, 2007; CANNON CANNON CANNON CANNON CANNON ® Instrument Company
2139 High Tech Road • State College, PA • 16803 • USA
6c. Loosen and remove
the two Phillips-
head screws
securing the drawer
unit to the brackets
inside the drawer
housing (see Figure
4b).
6d. Pull out the electri-
cal drawer using the
handles provided,
disconnecting the
two connection
cables as you do so.
CAUTION If it is plugged in, unplug the AC line (power) cord before you remove the
drawer!
6e. Pull the drawer completely free of the housing and set it aside.
6f. When the drawer is
removed, locate the
four 1/4-20 socket
head cap screws
visible at the top of
the drawer opening
underneath the bath.
6g. Using the Allen
wrench provided,
adjust the cap screws
until the bath top is
level and the tab slots
in the rear housing
are aligned with the
screw holes in the
vertical channel (see
Figure 4c). Then
replace the bath
drawer and secure it
using the Philips-head
screws previously
removed.
Figure 4c: tab slots properly aligned with
vertical channel screw holes
Figure 4b: Removing drawer screws