Checkline DT-329 - Manual (Page 22)

19
4.5 Parameter Setting Instruction
Press “MODE” until the LCD displays “P” (Parameter setting mode). Please refer to 4.2. Mode selection.
Press the “SET” key to cycle between the various parameter settings available (range, trigger edge and delay
time/delay angle). For more information regarding the various parameter settings, please refer to sections 4.5.2
through 4.5.4 below. Press the “MODE” key to store the settings and return to measuring modes.
Note: “MODE” key must be pressed to store settings.
Operation Expression
Measuring range setting
(Press “PHASE+”, “PHASE-“ key
or turn the dial to switch
the measuring range)
Press to cycle
between
parameters
Trigger edge setting
(Press “PHASE+”, “PHASE-“ key
or turn the dial to change
the trigger edge setting)
FLASH
SET SET SET SET
SET
Auto Range
Trigger
Edge Deley Deg
Flash Time
Ave Last Min Max
min
sec
h
Hz
○○○○
Auto Range
Trigger
Edge
Deley Deg
Flash Time
Ave Last Min Max
min
sec
h
Hz
○○○○
Auto Range
Trigger
Edge
Deley Deg
Flash Time
Ave Last Min Max
min
sec
h
Hz
○○○○
ms
Delay angle setting
(use dial to change settings)
Auto Range
Trigger
Edge
Deley Deg
Flash Time
Ave Last Min Max
min
sec
h
Hz
○○○○
ms
Delay time setting
(use dial to change settings)
SET
FLASH
PHASE PHASE PHASE PHASE+ + + +
Press to change
the selected
parameter setting
OR
Rotate the dial to
change
the selected
parameter setting
SET
MODE
Set and store parameter settings,
then go to Internal flashing mode
PHAS PHAS PHAS PHASE E E E- - - -
PHASE+
PHASE-