ChemoMetec YC-100 User Manual
Page 54
42
10.5 External Printer (optional)
An external impact or thermo printer may optionally be connected to the
NucleoCounter for the printing of test results.
For connection of a printer (Impact type CM no. 939-0003; thermo type CM type no.
939-0006) please refer to Technical Note 001 (Impact type CM no. 994-0013; thermo
type CM no. 994-0014).
The NucleoCounter is equipped with a printer output port. It is located just below the
USB connector on the rear side as apparent from Figure 34 and Figure 35
Figure
Figure
Figure
Figure 34
34
34
34 Location of the Printer output on
the NucleoCounter
Figure
Figure
Figure
Figure 35
35
35
35 Connecting the Printer cable to the
NucleoCounter (lower connector).
Table
Table
Table
Table 5
55
5 Description of the NucleoCounter Printer Output connector
Pin no
Pin no
Pin no
Pin no
Name
Name
Name
Name
Maximum Voltage level
Maximum Voltage level
Maximum Voltage level
Maximum Voltage level
7
77
7
1
8
2
Rx
±10 VDC
3
Tx
±10 VDC
Metal Enclosure
DGND
0 VDC
7
In normal operation. Refers to DGND Metal Enclosure. Taken from the datasheet for
MAX202ECSE.
8
There is no signal connected to pin 1.