COP-USA ALC-WF User Manual
Page 26
there is a font-end alarm event.
The settings are made as below:
Step 1: Check the box
『
Enable Alarm Record』
. When the system sets the alarm status, the
sub-option can record the video occurring when the alarm is present. The record time can be set
between 30 and 600 seconds.
Step 2: Check the box
『
Enable Alarm Linkage』
.
Step 2: In the
『
Server』
option, select the server to make alarm linkage.
Step 3: In the
『
Alarm Type』
option, select the alarm type.
There are three alarm types available:
『
Move Detect』, 『Probe Alarm』 and 『Video
Lost』.
Step 4: Check the box
『
Enable Record On Alarming』
(Channel 1 - 4 available)
Step 5: Click the
『
Apply』 and 『OK』
to save the parameters.
7.1.1.5.2 Alarm Sound Setup
The user can set the Move Detect Sound, Video Lost Sound and Probe Alarm Sound as
required.
Note: The sound file must be of wav format.
7.1.1.5.4 Auto Channel Popup for Alarm
When this item is checked and the server is in the logon status, the center management
software will automatically open the alarm channel and maximize the screen when there is an
alarm.
7.1.1.5.5 Hardware Decode
When you build the TV wall using the decoding card, it will display the status of DSP
channel.
For detailed settings, please refer to User Manual for Video Encoding Card.
『
TV Output Format』
It can configure different resolutions according to the actual situation
appearing on the monitor.
There are two resolutions available:
『
640*520』
and
『
704*576』
.
7.1.1.6 Local Log View
This item is used to view the system log file, and makes the user easily manage and use the
system. For details, please see the screen below: