COP-USA ALC-WF - Manual (Page 46)

Video loss warning Setting
Steps of setting:
Step I: Select『Channel』, enter『Alarm Type』, then select 『Video Loss』
Step II: Set the alarm time segment, select arming time and set the arming time segment
Step III: Tick and select『Linkage Alarm Output』
The system offers binary probe output for options; users may connect with external
alarm equipment e.g. alarm ring, alarm light, alarm signal, etc. In case an
emergency of video loss occurs, the system may automatically output binary to the
external equipment
Step IV: Set the time of alarm elimination (1~999 seconds)
Step V: Click『Setting』, save the parameters
8.9
PPPOE&DDNS Settings
Profile: According to the customer’s demands, if the fore-end accesses to network by dial-up,
users need to conduct the setting to PPPOE; while if the remote users need to access to DVS/IP
Camera via domain name, they can select DDNS supported by DVS/IP Camera to make settings.
Currently it can support three kinds of DDNS:
www.dyndns.com ；www.netnvr.com;