COP-USA DVR2704XE-L User Manual
Page 30
DVR User Manual
24
Full screen alarm: If selected, there will pop up the chosen channel on the
monitor on an alarm trigger.
To alarm out: If selected, this would trigger the external relay output on
detecting a sensor based alarm.
Email: If you select this option, the DVR will send an email alert to the
preconfigured email address in case of a sensor based alarm from the
particular input.
Snap: If selected, the system will snap images of the checked channels on
an alarm and save them in the HDD automatically.
Step 7: Enter into To Record tab. Select recoding channels. It would be
recorded in case of an alarm. Click OK button to save the setting.
Step 8: Enter into To PTZ tab. Set preset, cruise and track options for Fig 4-19 Sensor-Schedule
a PTZ in case of a sensor based alarm. Single or multiple PTZ units could be programmed to perform this function on the same alarm.
Step9: Enter into Schedule tab. Refer to Fig 4-19. The setup steps for schedule for sensor based alarm are similar to normal schedule setup.
You can refer to Chapter 4.4.1 Schedule for more details. This step is very important for sensor alarm. Even if you have enabled the sensor
alarm for all channels and setup the trigger, you will not see the result of sensor alarm if no schedule is added.
If you have set the schedule for senor based recording in the same timeline, recordings can also be triggered.
4.5.2 Motion
Motion includes two sub menus: motion and schedule.
The
steps
to
set
up
motion
alarm
are
as
follows:
Step1: Enter into MenuSetupAlarmMotion tab. Refer to Fig 4-20:
Step2: Enable motion alarm, set alarm hold time which refers to the time till which the
system will wait for further detection of motion. Eg.
If the holding time is set to 10 seconds, once the system detects a motion, it will go into
alarm but would not detect any other motion alarm (specific to channel) until 30
seconds. If there is other motion detected during this period, it is considered it as Fig 4-20 Alarm Configuration-Motion