COP-USA DVR2704XE-L User Manual
Page 34
DVR User Manual
28
device will distribute IP address, subnet mask, and gateway IP and DNS server. If you want to configure your own settings, please input
the IP address, Subnet mask, Gateway DNS server manually. You can also check the PPOE checkbox to enable this feature and then enter
username and password. Once the setup is completed, your DVR will automatically dial up into your network.
Step 4: No matter what kinds of way to connect internet, you should test the effectiveness of the network by clicking “Test” button after
you setup the network.
Step 5: If the network is well connected, please click “Apply” button to save settings.
4.6.2 Sub-stream
Step 1: Enter into MenuSetupNetwork Sub-stream tab. Refer to Fig 4-27:
Step 2: Select fps, resolution, quality, encode and max bit rate
Step 3: Select “All” to set the same settings for all channels.
Fig 4-27 Network Sub-stream
Parameter
Meaning
FPS
Range from: 1-6 (PAL)
Resolution
Support CIF
Quality
The higher the value is, the clearer the
record image. Six options: lowest, lower,
low, medium, higher and highest.
Encode
VBR and CBR
Max Bitrate
Range from:
768kbps~1792kbps