COP-USA DVR2704XE-L - Manual (Page 41)

DVR User Manual
35
Advance settings are as follows:
Step 1: Enter into MenuSetup P.T.Z Advanced tab. Refer to Fig 4-35:
Step 2: In the Advanced tab, click preset “Setting” button to see a dialog box as Fig 4-36:
Fig 4-35 P.T.Z Configuration-Advanced Fig 4-36 Advanced-Preset
Step 3: In the preset setting tab, while clicking Setting button, a dialog will
pop-up as Fig 4-37:

User can control the dome by rotating up, down, left, right and adjust
the rotating speed zoom, focus and iris of the dome;
 Select the serial number of the preset point. Click button to
enable the PTZ wiper and click button to enable the PTZ light. Fig 4-37 Preset Setting
Note: PTZ must support wiper and light, these two functional buttons can take effect. At the same time these two buttons are just available
when selecting PELCOP or PELCOD.
 Click Save button to save the settings, click icon to hide the tool
bar, right click to view the toolbar again; click icon to exit the current
interface.

In the preset interface, click OK button to save the setting; click Exit
button to exit current interface.
Step4: In the Advanced tab, while clicking cruise “Setting” button, a dialog
box will pop-up as Fig 4-38: Fig 4-38 Cruise Setting