COP-USA DVR2704XE-L - Manual (Page 35)

DVR User Manual
29
4.6.3 Email
Step 1: Enter into MenuSetupNetworkEmail tab. Refer to Fig 4-28:
SMTP Server/Port: The name and port number of SMTP server. Check the SSL
checkbox if the server requires a secure connection (SSL); user can setup mail servers
(such as Gmail) as required.
Send address/password: Sender‟s email address/password
Receive address: Receiver‟s email address. Here user can add at least three mail
addresses. Click TEST button to test the validity of the mailbox.
Attaching image: After selecting it, the system will attach images when sending the
emails.
Fig 4-28 Network Configuration-Email
4.6.4 Server
This function is mainly used for connecting ECMS. The setting steps are as
follows:
Step 1: In the server tab, select “enable” as shown in the Fig 4-29.
Step 2: Check the IP address and port of the transfer media server in the ECMS.
The default server port for auto report is 2009. If it is modified, please enter into
the transfer media interface to check.
Step 3: Enable the auto report in the ECMS when adding a new device. Then
input the remaining information of the device in the ECMS. After that, the
system will auto allot a Device ID. Please check it in the ECMS. Fig 4-29 Network Configuration-Server
Step 4: Input the above-mentioned server IP, server port and device ID in the server interface .Then click “Apply” button to save settings.
Now, the ECMS system will automatically connect this device.