Freerider FR168W - Manual (Page 11)

20 21
DISASSEMBLY
1. Disconnect the joystick and the power base. (See figure 18).
2. To separate the seat assembly and power base. (See figure 19).
Figure 18.Controller harness disconnects.
Figures 19.To separate the seat assembly and power base. Figure 19.The seat and height adjustment bolt.
COMFORT ADJUSTMENTS
When you find the need to make some adjustments to increase your comfort, such as seat height,
armrest angle and height, foot platform angle, and controller position. Refer to the following
information before making comfort adjustments.
WARNING! The center of gravity of your power chair was factory set to a position that meets
the needs of the demographic majority of users. Your Authorized Freerider Agent has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not change
your seating configuration without first contacting Freerider Mobility Products or your Authorized
Freerider Agent.
WARNING! Remove the occupant from the power chair before making any adjustments.
SEAT HEIGHT ADJUSTMENT
You can change the seat height to one of two positions in 1.2 in. (3 cm) increments.
To change the seat height:
1. Turn off the power to the controller.
2. Ensure the power chair is in drive mode. (See figure 9).
3. Disconnect the controller connector from the power base. (See figure 18).
4. Disengage the seat release lever. ( See figure 12.)
5. Swivel the seat lateral and then pull it up and off of the power base. (See figure 11).
6. Remove the seat height adjustment bolt from the seat post. (See figure 19).
7. Raise or lower the upper seat post to the desired position.
8. Reinstall the seat height adjustment bolt to the seat post.
9. Reinstall the seat.
10. Reconnect the controller to the power base.
COMFORT ADJUSTMENTS