GEA Bock F - Manual (Page 2)

2
D
GB
F
E
09702-09.2013-DGbF
1 Safety 4
1.1 Identification of safety instructions
1.2 Qualifications required of personnel
1.3 General safety instructions
1.4 Additional safety instructions NH
3
1.5 Intended use
2 Product description 6
2.1 Short description
2.2 Name plate
2.3 Type code
3 Areas of application F 9
3.1 Refrigerants F, F-NH
3
3.2 Oil charge
3.3 Operating limits
4 Areas of application F-NH
3
11
4.1 Oil charge NH
3
4.2 Operating limits NH
3
5 Compressor assembly 12
5.1 Setting up
5.2 Maximum permissible inclination
5.3 Pipe connections
5.4 Pipes
5.5 Laying suction and discharge lines
5.6 Operating the shut-off valves
5.7 Operating mode of the lockable service connections
5.8 Drive
5.9 Oil sump heating (standard by F4, F5, F14 and F16)
6 Commissioning 18
6.1 Preparations for start-up
6.2 Pressure resistance test
6.3 Leak test
6.4 Evacuation
6.5 Refrigerant charge
6.6 Shaft seal
6.7 Shaft seal change
6.8 Start-up
6.9 Avoiding slugging
7 Maintenance 21
7.1 Preparation
7.2 Work to be carried out
7.3 Spare parts recommendation
7.4 Spare parts recommendation NH
3
7.5 Accessories
7.6 Excerpt from the lubricant table
7.7 Decommissioning
8 Technical data F2-F16 23
9 Technical data F2 NH
3
-F16 NH
3
24
10 Dimensions and connections F 25
11 Dimensions and connections F-NH
3
33
12 Declaration of installation 41
13 Service 42
About these instructions
Read these instructions before assembly and before using the compressor. This will avoid misunder-
standings and prevent damage. Improper assembly and use of the compressor can lead to serious
or fatal injury.
Observe the safety instructions contained in these instructions.
These instructions must be passed onto the end customer along with the unit in which the compres-
sor is installed.
GEA Bock GmbH
72636 Frickenhausen
Manufacturer
Contact
GEA Bock GmbH
Benzstraße 7
72636 Frickenhausen
Germany
Telephone +49 7022 9454 0
Fax
+49 7022 9454-137
[email protected]
www.bock.de