Hangar 9 Piper J-3 Cub 40 ARF - Manual (Page 15)

15
 Step 14
Plug in the aileron servo to the radio system. Center the
trims on the transmitter to center the aileron servo. Hold
the aileron in neutral. Use a felt-tipped pen to mark the
pushrod wire where it crosses the servo arm.
 Step 15
Bend the pushrod wire at the mark. Use a pushrod wire
keeper to secure the pushrod wire to the servo arm.
 Step 16
Repeat Steps 1 though 15 for the remaining wing panel.
Required Parts
• Fuselage • Clevis
• Clevis retainer • Control horn
• Wing strut mount (2) • #4 x 3/8" screw (4)
• 19 3 /
4
" pushrod dowel • 6" pushrod wire
• Pushrod wire (32”)
• 2
1 /
8
" heat shrink tubing (2)
• 2mm x 12mm screw (3)
• 7
1 /
4
" pushrod wire (2)
Required Tools and Adhesives
• Phillips screwdriver • Hobby knife
• Drill • Drill bit: 3/32", 5/64"
• Heat gun • Medium CA
• Thin CA • Felt-tipped pen
 Step 1
Remove the covering for the wing strut mount. The
opening is located above the rear landing gear mount.
Section 3: Servo Installation (Aileron)
Section 4: Servo Installation (Fuselage)