Hangar 9 Pulse XT 40 ARF - Manual (Page 17)

17
Required Parts
•.Fuselage. •.Landing.gear
•.4mm.nut.(6). •.4mm.locknut.(2)
•.6-32.x.1/2".socket.head.screw.(3)
•.4-40.blind.nut.(4).
•.#6.washer.(3)
•.2
.
3 /
4
".(70mm).wheel.(2)
•.Wheel.pant.(right.and.left)
•.4-40.x.3/8".socket.head.bolt.(4)
•.4mm.x.40mm.socket.head.bolt.(2)
Required Tools and Adhesives
•.Hex.wrench:.3/32",.7/64". •.Drill
•.Drill.bit:.9/64".(3.5mm).
•.Threadlock
•.Felt-tipped.pen
 .Step 1
Attach.the.landing.gear.to.the.bottom.of.the.fuselage.using.
three.6-32.x.1/2".socket.head.bolts.and.three.#6.washers..
Put.a.little.threadlock.on.the.bolts.to.prevent.them.from.
vibrating.loose.during.flight.
 .  .Step 2
Slide.a.4mm.x.40mm.socket.head.bolt.into.a.wheel..Slide.
a.4mm.washer.onto.the.bolt.then.thread.a.4mm.nut.onto.
the.bolt..Leave.the.bolt.loose.enough.that.the.wheel.can.
spin.freely.on.the.bolt..Use.a.drop.of.thin.CA.or.threadlock.
to.keep.the.nut.in.position.
 .  .Step 3
Thread.a.second.4mm.nut.onto.the.bolt..Slide.the.bolt.into.
the.landing.gear..Place.a.second.4mm.washer.onto.the.
bolt,.then.start.the.4mm.locknut.onto.the.bolt..The.order.
is:.wheel,.4mm.nut,.4mm.washer,.4mm.nut,.landing.gear,.
4mm.washer.and.4mm.locknut.
Section 4: Landing Gear Installation