Hangar 9 Pulse XT 40 ARF - Manual (Page 19)

19
 .  .Step 7
Use.a.9/64".(3.5mm).drill.bit.to.drill.the.two.locations..
for.the.screws.
 .  .Step 8
Install.two.4-40.blind.nuts.inside.the.wheel.pants.through.
the.holes.drilled.in.the.previous.step.
 .  .Step 9
Secure.the.wheel.pant.to.the.landing.gear.using.two..
4-40.x.3/8".socket.head.screws..Make.sure.to.use.
threadlock.to.prevent.the.screws.from.loosening..
during.flight.
 .  .Step 10
Check.that.the.wheel.can.spin.freely.without.rubbing.on.
the.wheel.pant..If.it.does,.loosen.the.4mm.nut.and.4mm.
locknut.and.reposition.the.wheel.so.it.can.spin.freely.
 .Step 11
Repeat.Steps.6.through.10.to.install.the.remaining..
wheel.pant.
Section 4: Landing Gear Installation