Char-Griller LP Gas Grill Grillin Pro 3001 User Manual
Page 12
page 12
Step 10
Install the BURNERS into the GAS GRILL BODY by first inserting the open end of the
BURNERS through the holes directly behind the CONTROL PANEL and then onto the VALVE
tip. Make sure the valve tip is completely inside the hole on the end of the BURNER. The
BURNER with the long wire is installed on the right side of the GAS GRILL BODY. Secure the
other end of the BURNER to the GAS GRILL BODY with the SCREW provided. Again, make
sure the VALVE tip is completely inside the hole on the end of the BURNER.
Step 11
Insert the IGNITER WIRES, which are attached to the underside of each BURNER, through
the same hole in the GRILL BODY that the BURNER goes through and then attach the WIRE
to the backside of the ELECTRONIC IGNITER, which is attached to the CONTROL PANEL.
™ & © Char-Griller / A&J Mfg.
Igniter Wire
Electronic Igniter
Burner
Burner
Valve
Step 9
Attach the SIDE SHELF with four (4) ½” BOLTS and LOCK WASHERS as shown below.
Lock Washers
Bolts
Screw