Char-Griller LP Gas Grill Grillin Pro 3001 - Manual (Page 14)

page 14
Step 15
Before attaching WARMING RACK you must attach the warming rack BOLTS to the GRILL
HOOD and BODY. Insert the 1½” BOLTS through the holes in the sides of the HOOD from the
outside and tighten the HEX NUTS on the inside of the HOODS. Insert the
1½” BOLTS
through the holes in the sides of the GRILL BODIES from the outside and tighten the HEX
NUTS on the inside of the GRILL BODIES. Now, you can attach the warming racks to these
bolts as shown below and secure with HEX NUTS only finger tight.
Step 16
Set the POT STAND in place over the SIDE BURNER. Next install the FLAME SHIELDS over
the BURNER TUBES. Then set the COOKING GRATES in place and insert the UTENSIL
HOOKS into the SIDE SHELF.
™ & © Char-Griller / A&J Mfg.
Utensil Hooks
Screw
NOTE: Hose must go
under and to the outside
of the leg brace.
Step 17 1.
Place a standard 20 lb. LP gas cylinder (not included) into the cart assembly and connect the cylinder
with the gas hose/regulator as shown. (See “Operating Grill” on page for further instructions).
2. Turn the Screw on the left side of the base panel clockwise to secure the standard 20 lb. LP gas
cylinder.
Flame Shields
Cooking Grates