Hardy ANY-WEIGH Bench Scales - Manual (Page 19)

Chapter 4 - Configuration
4-1
CHAPTER 4 - CONFIGURATION
SCOPE The Universal Scale and the Analog Scale do not
require any configuration. The DeviceNet scale con-
figuration consists of setting the baud rate and node
address on a DIP switch which is accessible through
an access port on the bottom of the scale.
DeviceNet
Communication
Configuration
NOTE: Be sure to configure the DeviceNet Scale before plac-
ing any vessels or containers on the scale.
DIP Switch (S1)
Configuration Configuring the DIP switch sets the following:
1. Baud Rate
2. Node Address
DIP Switch
Location The DIP Switch is located through an access port on
the bottom of the scale. (See Fig. 4-1)
FIG. 4-1 DIP SWITCH LOCATION/BOTTOM VIEW
Chassis Ground
Attachment Point
CABLE
DIP SWITCH