Hardy ANY-WEIGH Bench Scales - Manual (Page 20)

Any-Weigh™ Series Bench Scales
4-2
Accessing the DIP
Switch Tilt the scale up until you can reach the DIP Switch
access port or if it is more convenient turn the scale
upside down so that bottom is facing up to reach the
DIP Switch access port.
NOTE: Scale must be connected to earth ground from the
Chassis Ground Attachment Point. (See Fig. 4-1)
Configuring the
Baud Rate Refer to Table 4-1 to configure the baud rate. 0 = OFF,
1 = ON (* is the default setting)
FIG. 4-2 FACTORY DEFAULT DIP SWITCH CONFIGURATION
Configuring the
DeviceNet Node
Address Refer to Table 4-2 to configure the DeviceNet Node
Address.
Baud Rate S1-7 S1-8
125 kbps* OFF OFF
250 kbps OFF ON
500 kbps ON OFF
500 kbps ON ON
Table 4-1: Baud Rate