KEYENCE LS-3100/3100W Series User Manual
Page 48
42
CHAPTER 4 Functions and Controls
6. Press CAL to calibrate segment selector Y. "CAL Y" will appear on the
subdisplay. You can display "CAL Y" by pressing CAL either when "CALIB
OK" appears or when "CAL X" has just been displayed by pressing CAL.
("CAL X" and "CAL Y" display alternately each time you press CAL.)
7. Repeat steps 2 to 5 just as you do for calibrating segment selector X.
8. When you finish the calibration, press any of SEG, MODE, AVE, LIMIT,
OFS, PRM, FNC, PROG, or DISP to return to the measurement mode.
• To return to the factory calibration, enter "0.0000" on the upper and lower
lines of the subdisplay.
• When "CALIB ERROR" appears on the subdisplay, press CAL to display
the return to the previous status.
• When you use only one of the segment selectors X and Y, you can
calibrate only the selector you use. When you finish the calibration, first
check that "CALIB OK" appears on the subdisplay, then press any of the
keys mentioned in Step 8 to return to the measurement mode.
• When you measure the diameter of two round bars with only one scan-
ning head, the measurement position differs one from the other. To
ensure higher accuracy, it is recommended that the reference gauge be
placed at each position and segment selectors X and Y be calibrated
separately.
• For even higher accuracy, the closer the dimension of the reference
gauge to the target size, the better.
• You cannot enter negative values.
• The value entered on the lower line of the subdisplay must be greater
than that on the upper line. If not, "CALIB ERROR" will appear.
C
L
0
Y
0 0 0
.
A
0
0
0 0 0
.
0
Example of Operation
You are to measure a diameter of round bars that can vary from 10 mm to
20 mm. Two gauges, each having 10.0100 mm and 20.1000 in diameter are
used for calibration.
Step
Key operation
Display
1
Press CAL to display "CAL
X".
2
Enter "10.0100".
3
Press ENT to register.
Cursor will move down.
(To be continued)
Note
C
L
0
X
0 0 0
.
A
0
0
0 0 0
.
0
C
L
0
X
0 1 0
.
A
0
0
0 0 0
.
0
[ 1
]
C
L
0
X
0 1 0
.
A
0
0
0 0 0
.
0
1
08.10.1, 10:55 AM
42