KEYENCE LS-3100/3100W Series - Manual (Page 61)

55
CHAPTER 4 Functions and Controls
Specifies and outputs the setting status of the desired program.
The format differs with the setting information to be output, as described
below.
Format:
( [P$] [Ø$] ) [COMMAND] CR
Note that one or both of the commands in ( ) can be omitted.
When [P$] is omitted, the current program No. will be valid.
When [Ø$] is omitted, CH1 will be specified.
Output of Setting Status
Output Channel
Program No.
[P$] [Ø$] List
Function Command Description
Specifying and X? Outputs setting information of
outputting segment selector X
setting information Y? Outputs setting information of
segment selector Y
XS? Outputs whether segment check
for segment selector X is set to
ON or OFF
YS? Outputs whether segment check
for segment selector Y is set to
ON or OFF
XN? Outputs preset value of segment
check for segment selector X
YN? Outputs preset value of segment
check for segment selector Y
TA? Outputs preset value of HIGH3 for
7-level differentiation
TB? Outputs preset value of HIGH2 for
7-level differentiation
TC? Outputs preset value of HIGH1 for
7-level differentiation
TD? Outputs preset value of LOW3 for
7-level differentiation
TE? Outputs preset value of LOW2 for
7-level differentiation
[COMMAND] List
(To be continued)
Function Command Description
Specifying P1 Specifies program No. 1
program No. P2 Specifies program No. 2
P3 Specifies program No. 3
P4 Specifies program No. 4
P5 Specifies program No. 5
P6 Specifies program No. 6
P7 Specifies program No. 7
P8 Specifies program No. 8
P9 Specifies program No. 9
PA Specifies program No. 10
Specifying output V Specifies CH1
channel W Specifies CH2
08.10.1, 10:56 AM 55