KEYENCE LS-3100/3100W Series - Manual (Page 58)

52
CHAPTER 4 Functions and Controls
Entry Examples
• To specify "1" for program No., "Y" for segment selector, "1" for scanning
head No., and SEG (3, 4) for measurement segment: "P1Y1S3,4 CR"
• To specify "2" for program No., "X" for segment selector, and "OFF" for
segment check: "P2XSR CR"
• To specify "3" for program No., "X" for segment selector, "1" for scanning
head No., and "DIA" for measurement segment: "P3D CR"
• To set the number of measurements for averaging to 1,024, while not
changing the other settings on the front panel: "AA CR"
Setting Output Conditions Sets the output conditions (processing methods for measured values) for the
desired program. The format differs with the setting item, as described
below.
Format:
( [P$] [C$] ) [COMMAND] CR
Note that one or more of the commands in ( ) can be omitted.
When [P$] is omitted, the current program No. will be valid.
When [C$] is omitted, the current channel No. will be valid.
Channel No.
Function Command Description
Setting tolerance IS Sets tolerance differentiation
differentiation output output to ON
IR Sets tolerance differentiation
output to OFF
Setting tolerance T3 Sets 3-level differentiation
differentiation level T7 Sets 7-level differentiation (3 or 7)
Setting tolerance TAn Sets value ("n") for HIGH3
range for 7-level TBn Sets value ("n") for HIGH2
differentiation TCn Sets value ("n") for HIGH1
TDn Sets value ("n") for LOW1
TEn Sets value ("n") for LOW2
TFn Sets value ("n") for LOW3
Setting values ASm, n Sets "m" for +6 V, and "n" for -6 V
("m" and "n") for (m > n)
analog output
voltage setting
[P$] [C$] List
[COMMAND] List
(To be continued)
Commands for setting functions
Function Command Description
Specifying program No. P1 Specifies program No. 1
P2 Specifies program No. 2
P3 Specifies program No. 3
P4 Specifies program No. 4
P5 Specifies program No. 5
P6 Specifies program No. 6
P7 Specifies program No. 7
P8 Specifies program No. 8
P9 Specifies program No. 9
PA Specifies program No. 10
Specifies output channel V Specifies output channel CH1
W Specifies output channel CH2
Program No.
08.10.1, 10:56 AM 52