To reduce the risk of electric shock or fire, Save these instructions, Awarning – Panasonic NI-W810CS User Manual

Page 3: Caution, Special instructions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

6. To avoid the risk of eiectric shock, do not operate iron with a damaged Cord or if

the iron has been dropped or damaged. Do not disassemble the iron.
Incorrect reassembly can cause a risk of electric shock when the iron is used.
For repair, take it to a qualified serviceman.

7. Close supervision is necessary for this appliance to be used by or near children.

Do not leave iron unattended whiie connected or on an ironing board.

8. Burns can occur from touching hot metal parts, hot water, or steam.

Use caution when turning the steam iron upside down. Hot water may leak from
the iron.

9. To protect against burns or injury to persons, do not direct steam toward the

body when ironing or self-cieaning.

10. The iron must be used and rested on a stabie surface. When placing the iron on

its Heel Rest, ensure that the surface on which the Heel Rest is piaced is stabie.

11. Do not use the appiiance with the Cord entangled. The supply Cord might be

damaged as a resuit.

SPECIAL INSTRUCTIONS

AWARNING

To reduce the risk of electric

shock or fire:

1. To avoid a circuit overload, do not operate another high wattage appliance on

the same circuit.

2. If an extension cord is absoiutely necessary, use a cord rated a minimum of 13

amperes. Cords rated for iess amperage may overheat and should not be used.

Care should be taken to arrange the cord so that it cannot be accidentaliy pulied
or tripped over.

A

CAUTION

To reduce the risk of personal

injury and damage to your iron:

1. Never use steam iron cieaning products in the iron, as they may damage working

parts of the iron.

2. Do not use water additives or substitute water such as linen or scented water

in the steam iron. They can stain fabrics.

3. If the Steam/Dry Selector is not in the Dry position after using, remaining water will

move into the Soieplate and can resuit in burns at the next use of the iron.

4. Don't use the Steam or Jet of Steam, while AC Cord is unpiugged, water will remain

inside the Solepiate which will cause staining.
Please do not use Steam or Jet of Steam while Temperature Selector Dial is set to
" Off".

SAVE THESE INSTRUCTIONS

For proper use of your iron, read remaining safety cautions and

operation instructions.

Advertising
This manual is related to the following products: