Panasonic NI-W810CS - Manual (Page 7)

Temperature Zone Steam/Dry Selector Position Recommendations
"Wool" to "Linen" Low Steam This is recommended for thin or delicate fabrics.
••• to "Linen"
?__s
Medium Steam
The Temperature is enough for normal steam
generation. From this temperature you can select
Low Steam, Medium Steam, according to the fabric.
" Linen "
if g
^ High Steam
There you can select any amount of steam, including
High Steam, for fabrics requiring a lot of steam
(i.e. thick materials, items with stubborn wrinkles).
Steam Zone
7. Whenever the iron is positioned verticaily, the steaming
action wiii stop.
A
CAUTION
Do not use the Steam/Dry Selector uniess the iron is sufficientiy hot to produce steam.
Water wiii ieak out through the vents instead.
Note:
Whiie using, the Auto-Vaive System wiii activate when the temperature of the soleplate's
surface drops. At the same time, the steam wiii stop. It is not a sign of malfunction when
you hear a clicking sound. (NI-W810CS/W750TS Only)
The Thermostat Operating Indicator Light will go on, wait until the Thermostat Operating
Indicator Light goes out.
HOW TO USE AS A DRY IRON
1. Move the Steam/Dry Selector to the Dry position.
2. Position the iron vertically, set the Temperature Selector Dial to " Off ".
3. Plug in the iron.
4. Set the Temperature Selector Dial to the desired position.
(Refer to the FABRIC IRONING CHART on page 12 )
5. Preheat the iron until the Indicator Light goes out, usually about 1 -2 minutes.
-
7
-