How to use the "spray" feature, Note, How to use the jet of steam "feature – Panasonic NI-W810CS User Manual

Page 8

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

HOW TO USE THE "SPRAY" FEATURE

Note:

Before using the spray feature, check the fabric iabei for ironing instructions. Some fabrics

may become spotted or stained with moisture.

The spray feature is particuiariy heipfui for removing stubborn wrinkies and where extra

dampening is needed.

The spray may be used with steam or dry ironing.

LJ

1. Simpiy pump the Spray Mist Button when spray is desired.

If the spray doesn't work immediateiy, keep pumping

untii it does.

2. To get a finer spray, pump the Button repeatediy.

To get a more powerful spray, pump the Button

slowly. For best results, use a quick, full stroke.

HOW TO USE THE JET OF STEAM "FEATURE

The"Jet of Steam"feature provides extra steam which goes deep into the garment and

is helpful for removing stubborn wrinkles. The "Jet of Steam" feature operates properly

only in the " Linen" position of the Temperature Selector Dial when steam or dry

ironing (If used at lower setting, water spotting will occur because the iron is not hot

enough to change water to steam ). If you have not used the" Jet of Steam " feature

for a long time, it is necessary to clean the inside of the iron before using this feature

on any clothes to be ironed. Simply test the "Jet of Steam" feature several times

away from the ironing board and clothes to be ironed. This will prevent brown spotting

or water spotting on the clothes.

1. Fill the iron as described in " HOW TO FILL WITH WATER'

2. Position the iron vertically and be sure the Temperature

Selector Dial is set to" Off".

Plug the AC Power Cord into the electrical outlet.

3. Set the Temperature Selector Dial to the " Linen" position.

4. Preheat the iron until the Indicator Light goes out, usually

about 1 -2 minutes.

5. Simply pump the " Jet of Steam Button " when steam is

desired. Pump the " Jet of Steam Button " several times

at the beginning of each ironing session.

6. Allow at least 2-5 seconds between uses of the "Jet of

Steam Button " to prevent water spotting. Use a press

cloth if necessary.

-

8

-

Advertising
This manual is related to the following products: