A&D Weighing MPA-1200 - Manual (Page 13)

11
7-2 Recharging the battery
When purchasing the instrument, the battery does not have a full charge. For initial
use, first charge the battery fully. Recharge the battery with the battery installed in the
pipette. Pipette use is available during recharging.
Recharging
1. Remove the power connector cover from the pipette.
2. Connect the power cable connected to the AC adapter to the power connector on
the pipette.
3. Connect the AC adapter plug to the outlet. The battery mark will be
displayed on LCD of the pipette, and it will blink during recharging. If connecting
the power cable to the outlet before setting the battery in the pipette, please note
that the recharging will not start. When the recharging is complete, the battery
mark changes from blinking to a steady illumination, then the recharging
completes automatically. (About five hours)
NOTE:
After recharging the battery completely, remove the power cable from the
pipette. Firmly attach the power connector cover by pushing it onto the
pipette.
Power connector cover
Power cable
（
Mini USB B type）
Power connector
(1)
(2)
(3)