A&D Weighing MPA-1200 - Manual (Page 28)

26
1 ) Setting the reverse mode
(The display is example.)
[ 1 ] Press the Back key.
[ 2 ] Press the Up or Down Key to select "SYS".
[ 3 ] Press the Enter key to enter the system
setting mode.
[ 4 ] Press the Enter key several times until
is displayed.
[ 5 ] Turn the blowout operation mode OFF
using the Up/Down key, then confirm this
selection by pressing the Enter key.
[ 6 ] Turn the reverse operation mode ON using
the Up/Down key, then confirm this selection
by pressing the Enter key.
[ 7 ] End the system setting mode by pressing the
Enter key while is being
displayed.