A&D Weighing MPA-1200 - Manual (Page 22)

20
[ 7 ] Press the Enter key to confirm the dispensing
count.
If you would like to change dispensing amount
or dispensing count, press the Enter key
before starting aspiration.
When setting, operate from step 4 described
above.
3) Operating the multiple dispensing mode
The following example is when dispensing 20μL x 10 times.
[ 1 ] Put the tip end into the liquid to be dispensed
and press the Operation key on the
pipette to aspirate the liquid
.
(The example shows 20μL x 10 times
= approx. 200μL)
[ 2 ] Put the tip end into a receiving vessel and press
the Operation key on the pipette to
dispense the amount for one time.
[ 3 ] In a similar manner, put the tip end into the next
vessel and press the Operation key to
dispense the liquid.