AAF International AAF-CY44-50 - Manual (Page 7)

3.4 Model/Style Specific Installation
Style Includes Installation
D1 Support legs and 55 gallon drum
assembly. (Most popular style) Attach flex hose to bottom of
cyclone and drum cover. Install
drum.
D2 Support legs, two 55 gallon drum
assemblies and Y fitting. Attach Y fitting with screws to
bottom of cyclone. Caulk.
Attach flex hoses, Y, and drum
covers.
H Dust storage hopper with slide gate
discharge and legs. (A separate
support stand is required.) Caulk where cyclone base plate
attaches to top of hopper.
A Motorized rotary airlock and receiver
for discharge of material. (A separate
support stand is required.) Attach receiver and airlock to
bottom of cyclone.
B Dust storage bin with door and pull
out drawer. Caulk where cyclone base plate
attaches to top of bin.
LS Cyclone and fan only. Requires
airtight dust container and support
legs. Connect bottom of cyclone to an
airtight dust container or
receiver and airlock.
__ Cyclone body only. Requires fan,
airtight dust container and support
legs. Connect bottom of cyclone to an
airtight dust container or
receiver and airlock. Attach duct
to fan.
NOTE: Body and cone for cyclone sizes 36, 44 & 48 are flanged and shipped in
2 pieces. Position the pieces so that inlet and blower discharge are in desired
locations. Apply caulking to either flange. Fasten with hardware provided.
IMPORTANT: All connections under the cyclone (drum, drum cover, flex hose, y
fitting, hopper, airlock, etc.) must be 100% airtight. Any slight leak will prevent
the dust from swirling downward and cause most of it to go out the exhaust or
overload the after filter bags if provided.
3.5 General Installation
1. Attach round to rectangular inlet to cyclone with straight side on top.
Use hardware provided and caulking.
2. Attach fan discharge elbow, transition or duct to fan discharge flange.
Protect fan discharge from fingers, birds, and weather.
- 5 -