Seat heaters, power windows, 2009 mdx – Acura 2009 MDX - Owner's Manual User Manual

Page 153

Advertising
background image

In the HI setting, the heater turns off
when the seat gets warm, and turns
back on after the seat's temperature
drops.

In the LO setting, the heater runs
continuously. It does not cycle with
temperature changes.

Follow these precautions when using
the seat heaters:

Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current from the
battery.

If the engine is left idling for an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting.

Power Windows

Turn the ignition switch to the ON
(II) position to raise or lower any
window. To open a window, push the
switch down and hold it. Release the
switch when you want the window to
stop. Pull back on the switch and
hold it to close the window.

The windows will operate for up to 10
minutes after you turn off the ignition
switch. Opening either front door
cancels this function.

Closing a power window on
someone's hands or fingers can
cause serious injury.

Make sure your passengers are
away from the windows before
closing them.

AUTO

- To open either front

window fully, push the window
switch firmly down to the second
detent, then release it. The window
automatically goes down all the way.
To stop the window from going all
the way down, pull back on the
window switch briefly.

DRIVER'S WINDOW
SWITCH

MAIN SWITCH

CONTINUED

Seat Heaters, Power Windows

149

Inst

rument

s

a

nd

Cont

rols

08/06/06 16:58:07 09 ACURA MDX MMC North America Owner's M 50 31STX620 enu

2009 MDX

Table Of Contents

Main Menu

Advertising