AERCO BMK 1.5 LN October 2012 - Manual (Page 91)

CHAPTER 8
TROUBLESHOOTING
PR1: 10/18//12 AERCO International Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 • Ph: 800-526-0288 Page 91 of 166
GF-120
OMM-0041 0E
Benchmark 1.5LN Low NOx Boiler
Installation, Operation and Maintenance Manual
CHAPTER 8. TROUBLESHOOTING GUIDE
8.1 INTRODUCTION
This troubleshooting guide is intended to aid service/maintenance personnel in isolating the
cause of a fault in a Benchmark 1.5 Boiler. The troubleshooting procedures contained herein
are presented in tabular form on the following pages. These tables are comprised of three
columns labeled: Fault Indication, Probable Cause and Corrective Action. The numbered items
in the Probable Cause and Corrective Action columns correspond to each other. For example,
Probable Cause No. 1 corresponds to Corrective Action No. 1, etc.
NOTE
The front panel of the C-More Control Box contains an RS232 port which
can be interfaced to a laptop computer or other suitable device. This
RS232 communication feature permits service personnel to view menu
items and data logs which can be useful in isolating faults. Refer to Chapter
9 of this manual for detailed RS232 communication set-up and procedures.
When a fault occurs in the Benchmark Boiler, proceed as follows to isolate and correct the fault:
Observe the fault messages displayed in the Control Box display. 1.
Refer to the Fault Indication column in Troubleshooting Table 8-1 which follows and 2.
locate the Fault that best describes the existing conditions.
Proceed to the Probable Cause column and start with the first item (1) listed for the Fault 3.
Indication.
Perform the checks and procedures listed in the Corrective Action column for the first 4.
Probable Cause candidate.
Continue checking each additional Probable Cause for the existing fault until the fault is 5.
corrected.
Paragraph 8.2 and Table 8-2 contain additional troubleshooting information which may 6.
apply when no fault message is displayed.
If the fault cannot be corrected using the information provided in the Troubleshooting 7.
Tables, contact your local AERCO Representative.