American Diagnostic Corporation (ADC) Adimals 2150 - Manual (Page 4)

Operating Instructions
Be sure to insert two AAA batteries before attempting to operate. 1.
Clean inside surface of oximeter and patient’s finger with 70% isopropyl alcohol before use. 2.
Squeeze the end opposite the power switch between the thumb and forefinger in order to open the device 3.
(there is a textured surface on the battery cover side to facilitate grip) (Fig 2)
Insert patient’s finger, nail side up into the device. (be sure to fully insert the patient’s finger so 4.
that the sensors are completely covered by the finger.) Index or middle finger is recommended.
Release the device allowing it to clamp down on the patient’s finger. 5.
Press the power switch on the front (top) panel to activate. 6.
Have patient keep still for optimal accuracy. 7.
Depending upon environmental and patient conditions, the device will begin to display readings 8.
in about 4 seconds.
Note readings on the display. 9.
Remove the patient’s finger from the de- 10.
vice by squeezing between forefinger and
thumb as indicated in Figure 2.
The display will indicate finger out. 11.
The unit will power off approximately 8 12.
seconds after the patient’s finger is removed from
the device.
Changing Oximeter Display Mode
There are six different display modes. The display modes alter the orientation of the display to facilitate
reading by the observer. Horizontal modes display the pulse wave form along with SPO2 and pulse
rate while vertical modes display a pulse rate bar graph along with the SPO2 and pulse rate readings.
To alter the display mode:
After the unit is powered on each brief press of the power switch will cycle through to the next display
mode in the sequence shown.
Note: The default setting is display mode 1.
Display Mode Cycle
Normal Horizontal
Wave Display
(Default Setting)
Normal Horizontal
Wire Display
(2nd click)
Normal Horizontal
(3rd click)
(Figure 2)
Handstand Horizontal
(4th click)
Normal Vertical
(5th click)
Handstand Vertical
(6th click)