2 rear panel – Avlink HX-331616 User Manual
Page 12
Matrix Switching System—User Manual
11
5.2 Rear Panel
Figure 5-2 HX-331616 Rear Panel
The HX-331616 supports up to 16 input / output jacks
(HDMI Type A), on the rear panel,
each female terminals form the signal input / output jacks. The HX-331616 signal input /
output terminal channels are numbered as IN1~16 / OUT1~16 channels. The input
terminal channels supply you to connect to different equipment including Blu-ray/DVD
players, graphics workstations, and number displays. The output terminals can be
connected to HDTVs, projectors, video recorders, displays and multiplexers and so on.
Power Port: The Power Port is applicable for 100~240VAC, 50~60Hz connected to the
outlet of power source. Refer to
錯誤! 找不到參照來源。
.
Power Switch: To switch power ON or OFF the Matrix Switcher.
RS-232: Use a 9-pin RS-232 cable to connect both computer serial port (COM1 or
COM2) and Matrix Switcher RS-232 communication port, refer to
6.6.1 RS-232
.
The
computer then can be deployed to control the Matrix Switcher after installing of
application software. Refer to
7.1 Software Introduction
for a software control or
Appendix D RS-232 Communication Protocol
for an individual configuration.
RS-485: Connection ports allow you to connect/control more than one Matrix product,
refer to
6.6.2 RS-485.
LAN Port: Use the RJ45 connection cable to connect the Internet and the Matrix
Switcher. The entire PCs at the same network can control the Matrix Switcher through
the LAN port. Refer to
6.6.3 LAN Port.
Switchers: HX-331616 supports 8 pins DIP switcher and 2 pins DIP switcher for
connected configurations. For more information, refer to
6.6 Ports and Switchers.
-
Pin 1~Pin5: ID
-
Pin 6: Master/Slave
-
Pin 7: RS-232/LAN
-
Pin 8: IP RESET