Avlink HX-331616 - Manual (Page 56)

Matrix Switcher Series—User Manual
55
Appendix B IR Mini-Controller
HX-331616 supports an IR Mini-Controller to allow you to select input channel through to
current output IR Rx port with an extended connection - IR Receiver Cable. The signal
for IR Mini-Controller is only available to the IR Receiver Cable connected on the
OUT1~OUT16 IR Rx port. The IR Receiver Cable connected on the IN1~IN16 IR Rx port
or IR EXT port is useless. If there are over 2 output IR receivers receive the signal, all of
them will be switched to the same selected input simultaneously. In order to avoid the
event occurs described above, you can configure the positions of your IR receivers
based on different environments. The IR Mini-Controller is optional.
ƒ 0~9 keys are used for channel selection.
ƒ and keys are used to increase or decrease channel . is specified to decrease
channel, alternately, is specified to increase channel. For example, press  keys to
add increased 1 channel to channel16; it will go back to channel 1. Otherwise, if you
are in channel 1, you can press key to go to channel 16.
ƒ Press Power key to switch to “0” (OFF).
ƒ Other keys are useless.
ƒ For channel configurations, e.g. channel 1, you can press “1” key and wait about 3
seconds, alternately, you can also press “01” keys to switch channel directly.