AXEON R1-Series User Manual

Page 27

Advertising
background image

MKTF - 211

6.

Re-install the end plugs by gently twisting the end cap while pushing it onto the housing. Ensure
that you do not pinch or fatigue any O
until the outer diameter of the plug is flush with the outer diameter of the pressure vessel.

7.

Insert the two half-moon retaining disks until they are fully seated. Subsequently fasten using a
#5 Allen wrench.

8.

Reconnect any fittings that may have been disconnected when
were disassembled.

9.

To Start-Up the system, please refer to the Initial Start

CAUTION: WET MEMBRANES ARE SHIPPED IN A PRESERVATIVE SOLUTION.

THE MEMBRANES MUST BE FLUSHED FOR AT LE
PRESERVATIVE FROM THE MEMBRANE. DISCARD ALL OF THE PERMEAT
PRODUCED DURING THE FLUSH PERIOD.

FIGURE 4

View from the back of R1-1500, R1
system.

27

211

install the end plugs by gently twisting the end cap while pushing it onto the housing. Ensure

that you do not pinch or fatigue any O-rings while re-installing the end plug. Push the end plug on

diameter of the plug is flush with the outer diameter of the pressure vessel.

moon retaining disks until they are fully seated. Subsequently fasten using a

Reconnect any fittings that may have been disconnected when the membrane pressure vessels

Up the system, please refer to the Initial Start-Up section of this manual. (See page 2

CAUTION: WET MEMBRANES ARE SHIPPED IN A PRESERVATIVE SOLUTION.

T BE FLUSHED FOR AT LEAST 30 MINUTES

PRESERVATIVE FROM THE MEMBRANE. DISCARD ALL OF THE PERMEAT
PRODUCED DURING THE FLUSH PERIOD.

1500, R1-3000, R1-4500, R1-6000, R1-7500, R1

07/26/12

install the end plugs by gently twisting the end cap while pushing it onto the housing. Ensure

installing the end plug. Push the end plug on

diameter of the plug is flush with the outer diameter of the pressure vessel.

moon retaining disks until they are fully seated. Subsequently fasten using a

the membrane pressure vessels

ion of this manual. (See page 28)

CAUTION: WET MEMBRANES ARE SHIPPED IN A PRESERVATIVE SOLUTION.

AST 30 MINUTES TO REMOVE THE

PRESERVATIVE FROM THE MEMBRANE. DISCARD ALL OF THE PERMEATE, WHICH IS

7500, R1-9000 reverse osmosis

Advertising