AXEON R1-Series - Manual (Page 6)

MKTF - 211
The amount of permeate water recovered for use is expressed as a percentage. To calculate % recovery,
use the following formula:
% Recovery = (Product Water Flow Rate / Feed Water Flow Rate) x 100
% Rejection = [(Feed TDS
NOTE: ALL FLOW RATES MUST BE EXPRESSED IN THE SAME UNITS.
SYSTEM REQUIREMENTS
PLUMBING
The membranes and high pressure pumps used on R1
with a minimum feed pressure of 4
FEED WATER CONNECTION
1. Locate the 1” FNPT Sole
(Figure 1A, Page 14)
2. Attach the inlet piping to the 1
3. Be certain that all of the
attained in the system.
PERMEATE (PRODUCT WATER) CONNECTION
Locate the 1” or 3/4” connection (Depending on the unit)
Ensure that the permeate water can flow freely
irreversible damage to the membrane elements.
be run to the holding tank with PVC fittings, or other FDA approved materials
being used does not leach into the permeate water.
CAUTION THE pH OF THE REVERSE O
BE 1-2 pH UNITS LOWER THAN THE FEED WATER PH. A LOW PH CAN BE VERY AGGRESSIVE
TO SOME PLUMBING MATERIALS SUCH AS COPPER PIPING.
6
211
water recovered for use is expressed as a percentage. To calculate % recovery,
% Recovery = (Product Water Flow Rate / Feed Water Flow Rate) x 100
Example:
26% = (1.04/4.00) x 100
% Rejection = [(Feed TDS – Product TDS) / Feed TDS] x 100
Example:
99% = [(550-5.5)/550] x 100
NOTE: ALL FLOW RATES MUST BE EXPRESSED IN THE SAME UNITS.
SYSTEM REQUIREMENTS AND OPERATION GUIDELINES
gh pressure pumps used on R1-Series systems require a continuo
feed pressure of 45 psi, not to exceed 90°F.
FEED WATER CONNECTION
” FNPT Solenoid Valve feed water inlet.
inlet piping to the 1” FNPT Solenoid Valve feed water inlet.
Be certain that all of the dissolved solids within the feed water are soluble at the concentrations
PERMEATE (PRODUCT WATER) CONNECTION
n (Depending on the unit) labeled permeate and attach to storage tank
sure that the permeate water can flow freely with no backpressure. Backpressure can cause
damage to the membrane elements. The 1” or 3/4” (Depending on the unit)
with PVC fittings, or other FDA approved materials.
into the permeate water.
H OF THE REVERSE OSMOSIS PERMEATE WATER WILL TYPICA
LOWER THAN THE FEED WATER PH. A LOW PH CAN BE VERY AGGRESSIVE
TO SOME PLUMBING MATERIALS SUCH AS COPPER PIPING.
07/26/12
water recovered for use is expressed as a percentage. To calculate % recovery,
% Recovery = (Product Water Flow Rate / Feed Water Flow Rate) x 100
Product TDS) / Feed TDS] x 100
OPERATION GUIDELINES
systems require a continuous flow of water
the feed water are soluble at the concentrations
labeled permeate and attach to storage tank.
Backpressure can cause
1” or 3/4” (Depending on the unit) permeate line can
. This is so the material
SMOSIS PERMEATE WATER WILL TYPICALLY
LOWER THAN THE FEED WATER PH. A LOW PH CAN BE VERY AGGRESSIVE