Buffalo Filter ViroVac - Manual (Page 6)

11
needs to be installed according to EMC information found in this manual.
12
trical equipment.
13
protection against harmful interference when the equipment is operated in a commercial
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at their expense.
14
RX modulation: Pulse-width coded, AM 100% modulation
TX Frequencies: Manchester encoded,
A = fc =/- 423.75kHz, B = fc +/- 484.29kHz
Low bit: transition A to B
High bit: transition B to A
patients.
1.4 Cautions and Warnings
1.4.1 WARNINGS:
• Read this manual thoroughly, and be familiar with its contents prior to using this equipment.
tory before shipment.
• Disconnect the unit from the electrical outlet prior to inspecting system components.
15. To isolate equipment from supply mains, unplug the power cord from the appliance inlet on
the unit or receptacle in the wall. Position the equipment to allow for ease of unplugging
power cord.
16. Potential Equalization Conductor: Terminal located on back panel for connection of potential
equalization. Conductor complies with requirements per IEC 60601-1 (2005).
are to be serviced by an authorized BUFFALO FILTER techni-
cian as follows: 220/240 VAC, 50/60 Hz use 3,15 Amp 250 Volt Fuse (Fast-Acting), (F3)
Please note that all Cautions and Warnings should be
equipment. read and understood before any use of this