Buick 2009 Enclave - Manual (Page 127)

Heated Windshield Washer
For vehicles with the heated
windshield washer fluid system,
it helps to clear ice, snow, tree sap,
or bugs from the windshield. This
feature only works with the front
wiper system.
The button is located to the left
of the steering column below the
instrument panel brightness
control knob.
Press the heated washer fluid button
to activate the heated windshield
washer fluid system. This activation
begins four heated wash/wipe
cycles. The first heated wash/wipe
cycle can take up to 40 seconds
to occur, depending on outside
temperature. After the first wash/
wipe cycle, it can take up to
20 seconds for each of the remaining
cycles. The system turns off
automatically after four wipe cycles
or the button can be pressed again
to turn it off.
Under certain outside temperature
conditions, steam might flow out
of the washer nozzles for a short
period of time before washer fluid
is sprayed. This is normal.
HEATING WASH FLUID WASH
WIPES PENDING is displayed on
the DIC when the washer system is
heating the fluid. WASHER FLUID
LOW ADD FLUID is displayed when
the washer fluid is low. See DIC
Warnings and Messages on
page 3-50.
Rear Window
Wiper/Washer
The rear wiper and rear wash
button is located on the instrument
panel below the climate control
system.
Z
(Rear Wiper): Press to turn the
rear wiper on and off. The wiper
speed cannot be changed.
Y
(Wash): Press to spray washer
fluid on the rear window. The window
wiper will also come on. Release the
button when enough fluid has been
sprayed on the window. The rear
wiper will run a few more cycles
after it is released. If the rear wiper
function was already on, prior to
pressing the wash button, it stays
on until the wiper button is pressed
again.
The rear window washer uses the
same fluid that is in the windshield
washer reservoir. See Windshield
Washer Fluid on page 5-25.
Instrument Panel 3-9