Buick 2009 Enclave - Manual (Page 8)

Power Lumbar
If the seats have power lumbar,
the controls used to operate this
feature are located on the outboard
side of the seats. See “Power
Lumbar” under Power Seats on
page 1-3 for more information.
To increase or decrease lumbar
support, press and hold the front or
rear of the control (C).
Release the control when the
seatback reaches the desired level
of lumbar support.
The lumbar support may need to
be adjusted when changing
the seating position.
Heated Seats
On vehicles with heated front seats,
the controls are located on the center
console. To operate the heated seats
the engine must be running.
I
(Heated Seatback): Press to
turn on the heated seatback.
J
(Heated Seat and Seatback):
Press to turn on or off the heated
seat and seatback.
The light on the button will come on
to indicate that the feature is on.
Each time the button is pressed,
the temperature settings change
from high, to medium, to low, to off.
Indicator lights above the button
will show the level of heat selected:
three for high, two for medium, and
one for low.
The passenger seat may take
longer to heat up.
If the vehicle has remote vehicle
start and is started using the remote
keyless entry transmitter, the front
heated seats will be turned on to
the high setting if it is cold outside.
See “Remote Vehicle Start”
under Remote Keyless Entry (RKE)
System Operation on page 2-4.
When the ignition is turned on, the
heated seat feature will turn off.
To turn the heated seat feature back
on, press the desired button.
Heated and Cooled Seats
If the front seats have the heated and
cooled seat feature, the buttons used
to control this feature are located on
the front doors near the door handle.
H
(Cooled Seat): To cool the entire
seat, press the button with the
cooled seat symbol.
This symbol will appear on the
climate control display to indicate
that the feature is on. Press the
button to cycle through the
temperature settings of high,
1-4 Seats and Restraint System